It had a rubber roof on it but it got damaged by being pulled under a tree limb.
Installing a rubber roof on an rv.
For rv purposes epdm is usually installed using an adhesive and the edges and trim are made watertight using additional sealants.
Your rubber roof probably came with some form of deck extension to make sure water runoff.
Relax the rubber.
Attach one by four furring strips over top of the felt spaced out 24 inches on center.
I am looking at buy a 1992 prowler fifth wheel travel trailer.
How to install an rv rubber roof 1.
Keep an eye out for dust dirt rust oil.
It comes in a variety of thicknesses and widths and is typically cut to length.
If you don t have an electric sander we recommend borrowing or renting one if possible.
Attach eave flashing along the bottom perimeter of the roof.
By donald tahlequah ok question.
Next we need to remove any termination bars drip edges strips.
Make sure your roof surface is spotless and dry.
Clean the roof surface.
You ll thank yourself later.
When it comes to the electric sander you can sand the decking of your rv s roof manually but unless your motorhome is relatively small it will be a lot of extra work.
Epdm roofs start to look chalky and some streaks may appear on the sides after it rains.
Epdm is an extremely durable synthetic rubber roofing membrane.
Regular cleaning and scheduled maintenance.
Epdm is a synthetic rubber membrane that is very durable and is commonly used on gently sloping roofs which are often found on rv s.
Replacing a rubber roof with a metal roof on a fifth wheel travel trailer.
The rubber roof on your rv is susceptible to the harsh rays of the sun and to airborne contaminates.
Remove all vents hoods housings.
If you spot an rv with a rubber roof that looks loose or swollen the owner most probably used petroleum products to clean it.
Continue until there is a board every 24 inches across the roof.
These elements can cause severe damage over time.
The first thing we need to do is remove any vents vent hoods and housings.
This chalky layer protects the rubber from degradation.