Nail the clapboard to the studs.
Installing beveled wood siding.
Bevel wood siding provides rustic warmth for homes and log cabins.
Install flashed water table at foundation.
Join the clapboards with scarf joints as in step 3.
How to install cedar bevel siding 1.
Siding may be installed starting with the bottom course.
Take care not to nail through the overlap of two pieces.
It is normally blocked out with a starting strip the same thickness as the top of the siding board see figure a.
Each succeeding course overlaps the upper edge of the lower course.
Seal all raw wood use building felt paper beneath the siding and use proper nails.
Bevel siding should be face nailed to studs with 1 1 4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center.
They are lapped to shed water.
Blind nail to wall framing.
Carefully slide the notched piece of siding into place.
Install corner trim on all corners typically 1 by 4 inch boards nailed vertically with the wide face of a board.
Layout fabricate and attach primed wood siding 6 width over vapor barrier.
Bevel siding also referred to as clapboard siding is a very popular wood siding product.
Seal all raw wood including edges of wood siding use building felt paper beneath the siding and use proper nails and nailing technique.
It is lumber that has been resawn at an angle resulting in two pieces.
Do not reduce the siding overlap recommendations given in the installation sections of this publication.
Siding should be nailed to each stud or on 16 inch centers.
Fasten a cedar starter strip.
Your wood siding will avoid water problems and damage if you follow some important tips.
Natural wood siding lap clapboard or beveled is still a common exterior finish.
Use scarf joints and caulk all seams.
Wood siding installation labor basic basic labor to install wood siding with favorable site conditions.
If more than one clapboard is needed to span a wall snap a chalk line between the marks on the corner boards on top of the course being overlapped.
Wrap the house with a polyethylene or similar moisture barrier stapled to the wooden wall sheathing with a.
One edge has a thick butt while the other edge is thinner.
Place nail just above the overlap.